Repeater Panels Based around two core products, the Remote Display Terminal (RDT) and the fully functional Remote control terminal (RCT) |
 |
- Remote terminals utilise the same graphical LCD user interface that can be found on the range of fire panels and are based upon the same advanced, flash based, microprocessor technology.
- All panels and remote terminals can communicate over the same 2-core network cable.
- Integral network Interface, which incorporates a special screen termination point for preventing mains frequency earth-loop currents following between network nodes.
- The network operates as a true peer-to-peer system with full cross panel reporting, control and cause and effect functoinality of up to 1000 zones .
- Fully on-site programmable via on-board alpha-numeric keypad or PC configuration tools.
- Both remote terminals incorporate buzzer mute, view, enable/disable and test facilities with dedicated system and navigation keys for simple user control.
- The 'RCT' has additional sector based control keys for evacuate, Silence, Resound and Reset, which allows other networked panels to selectively respond to controls as programmed. E.g. on a site with multiple buildings, a user may be allowed to silence and reset fires originating in their own building. Fires originating from other buildings are displayed but cannot be reset.
- The display information is fully programmable by individual zone or sector and can display any combination of fires, faults, pre-alarms or plant alarms. E.g. can display all information in its own sector, but only show fire signals from other sectors of a building.
